![]() Tftpboot 0x800000 openwrt-kirkwood-dockstar-u-boot.kwb Sysupgrade openwrt-19.07.7-kirkwood-seagate_dockstar-squashfs-sysupgrade.bin Installing CC 15.05 with console access via serial connection with UBIFS This tool should work, however, going forward after 19.07.7 and up: In theory you can also use the sysupgrade tool, but this is not recommended if you don't already have a modern bootloader, uboot config, partitions, etc. # Notes that rootfs_data is untouched! Anything in /overlay will be preserved. Mtd -r write openwrt-19.07.7-kirkwood-seagate_dockstar-squashfs-factory.bin root Opkg update & opkg install openssl-util libustream-openssl20150806 ca-certificates If you do not already have that, then this procedure will not work, and you will need Serial to recover. This procedure is only recommended after a modern bootloader and uboot configuration are already in place. Upgrading the bootloader to a modern version is a requirement for booting modern kernels (3.2+) and modern filesystems (ubifs).Īfter upgrading you can inspect the version of uboot and it should be: 0圆eddc, the size of data to write, which matches how big the file was when we ran the tftboot command Start location 0x0, the beginning of the flash where the bootloader goes 0x800000, the location in ram where our data was tftpd to NAND erase: device 0 offset 0x0, size 0圆eddc You could optionally erase the entire thing if you wanted to TFTP from server 10.0.2.10 our IP address is 10.0.2.11įilename 'openwrt-kirkwood-dockstar-u-boot.kwb'. # Save this output! Particularly the MAC address of ethaddrĬE> tftpboot 0x800000 openwrt-kirkwood-dockstar-u-boot.kwb ![]() Warning: If this procedure fails, JTAG is the only recovery option. ![]() The latest version of uboot that *does* work as a first-stage bootloader is from 14.07. The most recent versions of uboot on the OpenWrt downloads pages do *not* work as a first-stage bootloader.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |